Default Settings; Menu Structure; Operator Menu - Hach LANGE EVITA OXY Manuel D'utilisation

Default settings

The EVITA® OXY system is supplied with the following default settings.
USC 5000/7000
Parameter Default
setting
Current output 1 0–20 mg/L
(System package 2)
Current output 2 0–40 °C
Current outputs
OFF
USC 5000/7000
Relay 1, 2, 3, 4 and 5 OFF
(USC 7000)
TILTCAL® Activated
Passcode 1000
OXY 4100/4150
Parameter Default
setting
Oxygen measurement
mg/L
unit
Temperature
°C
measurement unit
Current output, if no
Low
measurement
Current output if fault Low
Time constant 40 seconds
English 98
Options
minimum 0 mg/L or ppm;
Range:
0 %
maximum 50 mg/L or ppm;
Measure
500 %
ment
minimum 1 mg/L or ppm;
range:
10 %
Range:
minimum -10 °C
maximum 70 °C
Measure
ment minimum 1 °C
range:
OFF
ON
Error, warning, limit, timer, OFF
Activated; Deactivated
1000–9999
Options
mg/L; ppm; %
°C; °F
High; Low; Hold
(last measurement value)
High; Low; Normal
10–300 seconds

Menu structure

The menu of the signal converter is divided into two parts. The operator
menu and the setup menu.

Operator menu

The operator menu is designed for daily use. After the language has
been selected, the signal converter begins each time in the operator
menu and shows the actual concentration of dissolved oxygen.
The model USC 5000 is designed for point-to-point installation, the
model USC 7000 for multidrop systems. In
marked menus are only visible via the multidrop system. There is also
the option to hide some menus within the operator menu (refer to
Figure 29, page 108).
Figure 19, page 99, gray