EUROM EK Delta 5000 Manuel D'utilisation page 16

Masquer les pouces Voir aussi pour EK Delta 5000:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
on and that no furniture is placed on top of it. Do not lead the cord around sharp
corners and do not roll it up too tightly after use! Do not turn or kink the cable and
do not wind it round the heater; this may damage the insulation!
If possible, do not use an extension cord, as this poses the
7.
risk of overheating and fire.
unavoidable, then make sure it is an undamaged, approved 4-core extension cord
with a minimum diameter of 1.5 mm², suitable for a minimum permissible power of
6000 Watt. To prevent overheating, always fully extend the cord! To prevent the
circuit overloading and fuses being blown, make sure no other appliances are
connected to the same socket or wired to the same electrical circuit as the heater.
Never use a single extension lead for more than one fan-heater, or for one fan-
heater and another item of electrical equipment!
Do not place the heater near, under or directly opposite a socket and do not place
it near an open fire or other heat source.
Do not use the heater outdoors and do not use it in spaces
8.
smaller than 40 mᶟ.
A heater contains hot and/or glowing and sparking
9.
components
liquids and/or gasses etc. are stored.
Do not use the heater near or directly opposite furniture,
10.
animals,
curtains,
inflammable objects
Make sure that the air around the heater can circulate freely. Do not place the
heater too close to walls or large objects and do not place it under shelves,
cupboards, and similar.
Never cover a heater!
11.
obstructed in any way, so as to prevent the possibility of fire. Never use the heater
to dry clothes and do not place anything on top of the heater. Do not place it on
soft surfaces such as beds or deep-pile carpets, as they can block openings.
Prevent foreign objects from entering the heater via the
12.
venting or exhaust openings as this may lead to electric
shock, fire or damage.
Never leave the heater unattended when switched on.
13.
switch if off before removing the plug from the socket. Always unplug the heater
when not in use! Pull on the plug to remove from the socket, never pull on the
cord. Always switch the heater off, unplug it and leave to cool down before:
-
cleaning the heater
-
carrying out maintenance to the heater
-
touching or moving the heater. Use the handle for this!
. Do not, therefore, use in areas where fuels, paint, flammable
paper,
. Keep them at least 1 metre away from the heater!
The heater's air inlets and outlets should never be
If the use of an extension cord is
clothes,
bedding
16
or
other
Always

Publicité

Table des Matières
loading

Table des Matières