EUROM EK Delta 5000 Manuel D'utilisation page 15

Technical data
Type
Supply voltage
Maximum capacity
Settings
Insulation class
Dimensions
Weight
General safety instructions
Before using the machine, carefully read this entire
1.
instruction manual.
Before using your new heater, check it, including cord and
2.
plug, for any visible damage
back to your dealer for replacement.
This heater is exclusively intended to heat workspaces such
3.
as workshops, garages and storage spaces
this purpose only.
Under the terms and conditions described in this leaflet, the
4.
heater can be used in wet or damp indoor spaces such as
bathrooms and laundry rooms
taps, bathtub, shower, pool, fountains or other sources of moisture (↔ > 1m.).
Make sure it cannot fall into water, Also make sure that it cannot come into
contact with jets of water, splashes, etc. and prevent water from getting into the
heater itself. If, at any time, the heater does fall into water, unplug it immediately!
Do not use a heater that has a damp interior but have it repaired. Never immerse
the heater, cord or plug in water and never touch it with wet hands.
The supply voltage and utility frequency, specified on the
5.
machine, need to match those of the socket that is used.
electrical installation needs to be protected by a residual current device (max. 30
mAmp). Never attempt to find a way round the safety features!Only connect the
heater to an earthed socket!
Fully extend the cord before plugging in the heater. Make
6.
sure it does not come into contact with any part of the heater
and prevent it from heating up any other way.
underneath carpeting; do not cover it with mats, carpet strips or similar and make
sure it is not placed in any passageways. Make sure the cord cannot be stepped
English
EK DELTA 5000
Volt/Hz 400V / 50Hz (3~)
Watt 5000
Fan – 2500 - 5000
Watt
IP24
cm 24 x 26 x 40,5
kg 4,8
. Do not use a damaged heater, but send it
. Do not place the heater in the vicinity of
15
. Use the appliance for
Do not run the cord
The