Télécharger Imprimer la page

BFT CELLULA 180 Instructions D'installation page 7

Publicité

MANUALE PER L'INSTALLAZIONE
1) GENERALITÁ
Fotocellula Mod. Cellula 180 per applicazione esterna, costituita da una coppia
trasmittente ricevente.
2) DATI TECNICI
DCW TX + DCW RX
Tensione di alimentazione
Corrente Assorbita
Portata contatti
Grado di protezione
Temperatura di esercizio
Portata Utile
Dimensioni
Categoria secondo la EN954-1
3) CORRETTO ALLINEAMENTO Fig. A
4) CORRETTO ALLINEAMENTO DI DUE COPPIE DI FOTOCELLULE Fig. B
5) FORATURA PER INSTALLAZIONE Fig. C
6) PASSAGGIO CAVI (Fig. D):
- attraverso il foro posteriore Rif. 1A
- attraverso il pressacavo Rif. 1B
7) COLLEGAMENTI Fig. E
8) CORRETTO ALLINEAMENTO Fig. F
9) COLLAUDO Fig. G
Al termine del collaudo, eseguire alcune manovre di prova e verificare che,
quando si interrompe il fascio interponendo un ostacolo, l'automazione reagi-
sca correttamente.
INSTALLATION MANUAL
1) GENERAL INFORMATION
Cellula 180 photocell for external application, comprising a transmitter-receiver
pair.
2) SPECIFICATIONS
DCW TX + DCW RX
Supply voltage
Current demand
Contact capacity
Protection rating
Operating temperature range
Portata Utile
Operating range
Category according to EN 954-1
24 V~/=
TX: 12mA
RX: 10mA a riposo / 15mA max
30V, 1A
IP55
-20/+55°C
30 m (ridotta in caso di nebbia-pioggia)
130X45X43 (HxLxD)
Cat 2
24 V~/=
TX: 12mA
RX: standby 10mA / max. 15mA
30V, 1A
IP55
-20/+55°C
30 m (ridotta in caso di nebbia-pioggia)
130X45X43 (HxLxD)
Cat 2
3) CORRECT ALIGNMENT Fig. A
4) CORRECT ALIGNMENT OF TWO PAIRS OF PHOTOCELLS Fig. B
5) HOLES FOR INSTALLATION Fig. C
6) CABLE ROUTING (Fig. D):
- through hole in back Ref. 1A
- through cable clamp Ref. 1B
7) WIRING Fig. E
8) CORRECT ALIGNMENT Fig. F
9) INSPECTION Fig. G
Once inspection is complete, perform a few test cycles and check that the au-
tomated system reacts as it should when the beam is broken by placing an ob-
stacle in the way.
MANUEL D'INSTALLATION
1) GÉNÉRALITÉS
Photocellule Mod. Cellula 180 pour extérieur, forme par une paire d'émetteur-
récepteur.
2) ONNÉES TECHNIQUES
DCW TX + DCW RX
Tension d'alimentation
Courant Absorbé
Portée contacts
Degré de protection
Température de service
Portée Utile
Dimensions
Catégorie conformément à
EN954-1
3) LIGNEMENT CORRECT Fig. A
4) ALIGNEMENT CORRECT DE DEUX PAIRES DE PHOTOCELLULES Fig. B
5) PERCEMENT POUR INSTALLATION Fig. C
6) PASSAGE DES CÂBLES (Fig. D):
- à travers le trou arrière Réf. 1A
- à travers le presse-câble Réf. 1B
7) CONNEXIONS Fig. E
8) ALIGNEMENT CORRECT Fig. F
9) ESSAI Fig. G
A la fin de l'essai, faites quelques manœuvres d'essai et vérifiez si l'automatisa-
tion réagit lorsque le faisceau est interrompu par un obstacle.
24 V~/=
TX: 12mA
RX: 10mA au repos / 15mA maxi
30V, 1A
IP55
-20/+55°C
30 m (réduite en cas de brouillard ou de pluie)
130X45X43 (HxLxD)
Cat 2
CELLULA 180 - 7

Publicité

loading