Dante™ Network; Automix Algorithm - Harman AKG DMM14 U Mode D'emploi

Description
Dante™ network
Algorithm for
Automix
DMM14 MANUAL
The audio transmission via cascading is carried out in 24Bit. This does not
impair the noise values.
5.4.10 Dante™ network
DANTE
REC (OUT) IN - EXPANSION - OUT
Figure 15: Dante
™
The DMM14 ULD is equipped with an 8-pin (RJ-45) modular jack labeled
DANTE (19).
All inputs and outputs are thereby automatically routed to the Dante™
network.
The inputs are routed to the Dante™ network after signal processing (treble,
bass,...) and after the automix algorithm as direct-out signals.
The output masters are routed before the balance regulator, before volume
out and before limiter to the Dante™ network as direct out signals.
Settings must be made via the Dante™ receiver unit (e.g. mixing desk).
When cascading automixers, note that only the channels available locally on
an automixer can be transmitted via the Dante™ network. If in addition the
inputs of another, cascaded device are required, this device must also have
a standalone Dante™ interface.
If multiple devices are also to be operated in the automix, these must also
be connected via cascading: Specifically, in addition to the master signals,
the control signals of the automix algorithm are also transmitted.
5.5

Automix algorithm

The unit's automix algorithm has 3 basic functions which assess the amount
by which an input signal is to be attenuated and the output signal's output
level. The following functions and parameters flow into the automix algo-
rithm:
• Dynamic level adjustment
• Best Mic On
RS232
86