Feed Via Usb And Dante; Processing The Feed; Activating Phantom Power; Using Presets - Harman AKG DMM14 U Mode D'emploi

operAting the Device
Feed via USB and
Dante™
PRESET
DMM14 MANUAL
8.5

Feed via USB and Dante™

8.5.1

Processing the feed

To feed the input signals via USB or Dante™, proceed as follows:
Step Description
Press the SYSTEM CONTROL rotary knob twice briefly (dou-
1
ble-click)
•
•
•
•
The inputs from USB Port are assigned to channels 13 (IN1 / USB L) and 14
(IN 2 / USB R), for devices without Dante™ interface the digital inputs 15 to
24 are without function and inactive.
For devices with Dante™ interface, the remaining digital input channels from
channel 15 are assigned as follows:
• IN3 / DANTE 1
• IN4 / DANTE 2
• etc.
All digital inputs have the same signal processing functionalities as the
analog inputs.
8.6

Activating phantom power

Only bridge the 0 V potential with the grounding (factory setting) or connect
it to the central system ground, as otherwise the phantom power has no
reference point and will not function.
8.7

Using presets

The presets on the DMM14 U (UL, ULD) function in a very similar way to the
presets on a car radio.
8.7.1

Selecting a preset

To select a preset, proceed as follows:
The 12 input controls are switched over for operation.
The LEDs IN USB and IN USB/DANTE are permanently lit
Changes to the input controls no longer affect the 12 ana-
log inputs; only digital inputs 13 to 24
The remaining operation is the same as on the analog level
118