Commissioning; Insert Batteries Into The Transmitter; Connecting The Antennae - Harman AKG DMS800 Mode D'emploi

commissioning

DMS800 MANUAL
6 Commissioning
Before commissioning your DMS800, check that the transmitter and receiver
are set to the same frequency.
To commission the DMS800, proceed as follows:
1.

Insert batteries into the transmitter

2. Connect the antennae
3. Position the receiver
4. Connect the receiver to the mixing console/amplifier
5. Reposition the GROUND LIFT switch (optional)
6. Connect the receiver to the power network
6.1 Insert batteries into the transmitter
Step Description
Open the battery compartment cover (9)
1
Insert batteries into the battery compartment.
2
When inserting the batteries, note the symbols in the battery
compartment to ensure the power supply.
Close the battery compartment cover (9)
3
6.2

Connecting the antennae

The following antennae can be mounted on the receiver:
λ/4 antennae (included as standard)
•
For all applications where there is a line of sight between the trans-
mitter and receiver antennae.
Remote antennae
•
For applications where the reception conditions are not optimal at
the receiver position.
77