Troubleshooting - Harman AKG DMS800 Mode D'emploi

troubleshooting

16 Troubleshooting
ERROR POSSIBLE CAUSE
No sound Errors due to other wireless systems, TV,
radio, wireless devices or harmful electrical
equipment or installations.
Transmitter set to a frequency different from
the receiver.
Transmitter switch or MUTE switch on
"MUTE".
Mains cable is not plugged into the receiver
and/or mains socket.
Receiver is switched off.
Receiver is not connected to the PA system.
Microphone or instrument is not connected
to the bodypack transmitter.
Batteries incorrectly inserted in the transmit‑
ter.
Transmitter batteries or rechargeable batter‑
ies empty.
Transmitter is too far away from the receiver.
Barriers between the transmitter and re‑
ceiver are creating shadows on the transmit‑
ter signal.
No line of sight between the transmitter and
receiver.
Receiver too close to metallic objects.
Software on the transmitter and receiver
does not match.
Distortions GAIN set too high or too low.
Suboptimal DSP settings.
DMS800 MANUAL
CORRECTION
Switch off other wireless systems
Set transmitter to the frequency
Switch on transmitter or press the MUTE
switch
Plug mains cable into the receiver and/
or mains socket
Switch on the receiver
Connect receiver to the PA system
Connect microphone or instrument to
the bodypack transmitter
Check the insertion direction of the bat‑
teries in the transmitter
Replace transmitter batteries or re‑
chargeable batteries
Move the transmitter to the receiver
Remove the barriers between the trans‑
mitter and receiver
Ensure a clear line of sight between the
transmitter and receiver
Remove receiver from metallic objects
Check the software
Check the DSP settings
111