Harman AKG DMS800 Mode D'emploi page 107

functionAl descriPtion
DMS800 MANUAL
Submenu Function
DSP Edit audio signal directly on the receiver
Settings can be stored in one of the nine DSP profiles
in a freely selectable name.
The digital signal processor offers the following dy‑
namic editing functions:
Low Cut (frequency: 10 – 300 Hz)
3‑band equaliser (low: ±20 dB, 80 Hz shelving; para‑
metric mid: ±20 dB, 100 Hz to 10 kHz, Q = 2; high:
±20 dB, 8 kHz shelving)
dbx® compressor (threshold: ‑60 ‑ +9 dBV, ratio: 1:1
– 1:10, gain: 0 – 20 dB, attack: 1 – 100 ms, release:
1 – 2000 ms)
dbx® limiter (threshold: ‑20 – +9 dBV)
Changes to a profile always affect both channels. All
previous settings of a profile are overwritten.
ATTENUATION Modify the level of the balanced audio output to the
PAD input sensitivity of the connected equipment
With microphone inputs, the setting 0 dB can result in
overloads.
If the receiver is connected to a microphone input, it is
recommended to select ‑30 dB.
The unbalanced line output cannot be controlled.
ENVIRONMENT This function works in a similar way to a spectrum
SCAN analyser.
UNLIMITED SCAN: the entire frequency band of the
receiver is searched for active radio frequencies
LIMIT SCAN: only a part of the frequency band is
searched for active radio frequencies
During the search process, the audio output remains
muted and the display shows the result graphically.
Turn the SELECT wheel: Move the curve to the left or
right
Press SELECT: Enlarge curve
107