Harman AKG DMS800 Mode D'emploi page 112

troubleshooting
ERROR POSSIBLE CAUSE
Brief dropouts at Receiver or antennae incorrectly positioned
some points of
the action area.
Transmitter is too far away from the receiver.
RF LOW The field strength of the reception signal
is so low that the receiver is automatically
muted to avoid interference noise.
AF CLIP The audio signal overrides the A/D converter
of the transmitter.
ANT ERROR The same antenna has already been active
for more than two minutes.
LOW BATT The capacity of the transmitter battery will
soon be depleted.
SYSTEM ERROR Internal error.
RF ERROR, Receiver cannot be synchronised to the set
PLL ERROR frequency.
UPDATE System is ready for software updates.
FIRMWARE
INTERFERE Errors due to other wireless systems, TV,
ERROR radio, wireless devices or harmful electrical
equipment or installations.
ENCRYPTION! Encryption not set correctly.
Errors due to other DMS800 transmitters.
DMS800 MANUAL
CORRECTION
Reposition receiver or remote antennae.
If dropouts remain, mark and avoid criti‑
cal points.
Move the transmitter to the receiver
Reposition receiver or use remote
antennae.
Reduce audio input level.
Check if the antenna cable is faulty or
incorrectly connected.
Insert new batteries.
Switch off receiver and switch back on
after approx. 10 seconds. If the error
occurs again, contact your AKG service
centre.
Tap the SELECT wheel to confirm errors
and set another frequency. If the error
occurs again, contact your AKG service
centre.
Switch off receiver and switch back on
after approx. 10 seconds. If the error
occurs again, contact your AKG service
centre.
Change frequency or switch off device
creating the interference.
Synchronise transmitter.
Change carrier frequency (resynchro‑
nise)
112