Cleaning And Care - SOLIS CITRUS JUICER PRO Mode D'emploi

CLEANING AND CARE

▲
Before disassembling or cleaning the appliance, please always check if the cit-
•
rus juicer has been switched off with the ON/OFF switch (position 0) and the plug
is pulled. Of course, this also applies if you want to reassemble or store the appli-
ance.
As described below, all surfaces and appliance parts that come into contact with
•
foods while juicing should be cleaned carefully.
We recommend rinsing all removable parts (juice collector with juice spout, pulp
•
filter, juicing cone and squeezing cone) immediately after use in warm water to
remove the still-wet pulp and the pips. Let all parts air dry before reassembling
them.
For thorough cleaning, all removable parts should be cleaned with warm dish
•
water or in the top drawer of the dishwasher.
The motor base and the lever press arm should be thoroughly cleaned with a
•
slightly wet cloth. Let all parts dry completely before reassembling them. Never
submerge the motor base, the power cord or the power plug in water or other
liquids.
Store the cleaned and fully assembled citrus juicer in an upright position at a cool,
•
dark place, best in the original packaging. Do not place anything on the appli-
ance or the packaging while in storage.
Notes:
Rinse or clean all removable appliance parts immediately after use. Dried citrus
•
fruit pulp is difficult to remove and might cause stains. Should any stains appear,
wipe the affected areas clean with undiluted dishwashing liquid and a wet cloth.
Rinse the accessories and dry everything carefully.
Do not place the pulp filter or the other removable parts in bleach.
•
Never use aggressive or scouring detergents or solutions to clean the motor base
•
and the appliance parts – they might scratch the surface.
51