CLEA NING A ND MAINT E NANCE
s
The appliance should be cleaned after every use.
●
Before cleaning, switch the appliance off with the rotary control (OFF position)
●
and wait for the appliance to come to a standstill.
Remove the juice jug and the pomace container from the appliance.
●
Disassemble the appliance as described. We recommend pulling the sieve out
●
of the appliance together with the juicer bowl and then turning the juicer bowl
upside down to remove the sieve. Like this, you avoid coming into contact with
the grating blades.
Should you pull the sieve out separately, you must only touch the sieve by the
upper edge, so that you do not touch the grating blades. Caution: The grating
blades are very sharp!
All removable parts can be cleaned in water. The motor unit on the other hand
●
must never be submerged in water! After that, dry all parts carefully.
You can clean the removable parts in warm (not above 50°) dish water with a
●
sponge resp. clean the sieve with the supplied brush.
Clean the motor unit with a slightly moist towel and some mild detergent.
●
Make sure that all parts are completely dry before reassembling the appliance.
●
In general, do not use any aggressive or scouring detergents or metal sponges,
●
as these might damage the surface.
GB
91