Assa Abloy OneSystem Instructions De Montage page 58

!
A
Typical installa-
tion of a door
fitting
EN
58
Installing door fittings (according to DIN EN 179)
Warning!
Life-threatening danger and risk of injury resulting from incorrect installa-
tion of door handle fittings according to with DIN EN 179: Only escutcheons,
lock counterparts, and coverings approved according to DIN EN 179 may be used
("Accessories, warranty, disposal", page 67).
Attention!
Property damage after drilling through the lock: The lock is damaged by drill-
ing. You may only use existing holes drilled at the factory to attach door fittings.
The lock must be removed prior to drilling.
Damage from dirt: The lock is damaged by dirt. Prior to installation, the lock
pocket and all holes must be cleaned (by blowing out or vacuuming).
Property damage due to forceful installation of the handle pin into the fol-
lower: The door handle spindle must be gently inserted into the spindle hub. No
tools are needed.
The lock must be installed in the door so that the holes for the door fittings can
be marked ("Installing the lock", page 53, "Maintenance", page 66).
Install the door fittings as described in the accompany instructions. The following
installation steps are typical:
1. Insert the handle pin in the follower (Fig. 10 –
2. Mark the drilled holes (
Normally, a drilling template accompanies the door fitting.
3. Remove the lock from the door.
4. Drill the holes.
5. Re-install the lock.
6. Install the door fittings on both side of the door (
7. Check the door handle for ease of movement.
 You have installed the door fitting and can operate the lock with the door
handle.
2
).
1
).
3 6
to ).
Safety instructions