Assa Abloy OneSystem Instructions De Montage page 56

!
Fig. 7 :
Follower with
adjusted panic side
Fig. 8 :
Adjust the panic
side
EN
56
Changing the panic side
The panic side of the lock must be adjusted before installation. The panic side of
the lock must be adjusted such that the door can be opened in the escape
direction (normally outward from inside) with the door handle, regardless of the
locking status of the lock.
Warning!
An incorrectly adjusted panic side can result in life-threatening danger and
risk of injury: After installing the lock, check whether the locked door can be
opened in the escape direction.
1.
2.
Fig. 7 shows one of the two possible
initial situations. The locking screw is
always located on the panic side.
(Fig. 8)
1. Unscrew the locking screw.
2. Push the sliding mechanism down.
3. Push the sliding mechanism on the
lock side up.
4. Fix the sliding mechanism in the
upper position with the locking
screw.
5. Optional monitoring:
Switch DIP switch 3 to the changed
panic side ("DIP-Switch", page 69).
 The panic side is adjusted such that
the door can always be opened in
the escape direction.
4.
3.
Safety instructions