Monogram ZV830 Manuel Du Propriétaire page 9

Questions?
PROBLEM
FAN FAILS TO CIRCULATE
Use this
AIR OR MOVES AIR
problem
SLOWER THAN NORMAL
solver!
FAN KEEPS GOING
OFF AND ON
LIGHTS WILL NOT WORK
AND RINGS AROUND THE
OPERATING BUTTONS
ARE FLASHING
LIGHT WILL NOT STAY
ON HIGH SETTING
THE HOOD CONTROLS
ARE NOT OPERATING
CORRECTLY
SEQUENTIAL PRESSES
OF THE LIGHT OR FAN
BUTTONS WILL CHANGE
THE SETTING FROM THE
LOWEST SETTING TO OFF
TO THE HIGHEST SETTING,
OR FROM THE HIGHEST
SETTING TO OFF TO THE
LOWEST SETTING
WHEN PRESSING THE
MEMORY/OFF BUTTON
TO TURN ON THE LIGHT,
THE FAN COMES ON
INSTEAD
The Problem Solver
POSSIBLE CAUSE
• Check to be sure the metal grease filter and the charcoal filter
(if present) are clean. Clean the metal grease filter (see the Metal
grease filter section) and, if the hood is recirculated (not vented to the
outside), replace the charcoal filter (see the Charcoal filter section).
If cleaning and replacing the filters does not correct the problem,
call for service.
• The motor is probably overheating and turning itself off. This can
be harmful to the motor. Check to be sure the filter is clean and
check ductwork for blockage. If off and on cycling continues, call
for service.
• Light(s) were replaced with bulbs with greater than the 120 volt, 50
watt limit. Replace with the correct type and size bulb. See the
Light bulbs section.
• Use 120 volt, 50 watt, MR16 halogen bulbs with a GU10 base and
make sure they are inserted securely. It is important to replace with
bulbs that do not exceed the recommended wattage. Higher wattage
bulbs will cause the outer rings to blink, and the lights will not
function at the highest levels. See the Light bulbs section.
• Disconnect power to the hood by turning the circuit breaker off or by
removing the fuse in the home fuse box. Wait 30 seconds to allow the
hood controls to reset and then replace the fuse or move the circuit
breaker back on.
• So that you can easily set the controls to the desired setting, the hood
is designed for the light and fan buttons to cycle through the settings.
This is normal.
• For your convenience, it is normal for the lights and fan to remember
their last setting when you press the Memory/Off button. If you
want only the lights on, press the "FAN +" (or the "FAN –" ) button to
turn the fan off. When you power the hood up next time, only the
lights will function. NOTE: You may turn the fan and lights off or on
separately, using the "+" or "–" buttons.
Chimney Hood
9