Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL Bavaria BSM 500 Mode D'emploi

Anl BSM 500_SPK1:_ 14.06.2007
Secure all workpieces to be processed
sufficiently.
Do not allow children to have access.
Make sure you have a secure stance on ladders
or scaffold-ing when using the drill freehand.
Localise lines with a line detector in walls where
power, water or gas lines are laid invisibly.
Wear protection goggles and use a dust mask for
dust-producing work.
Always arrange for a qualified electrician to carry
out repairs
Use only original replacement parts
The level of noise at the workplace may exceed
85 dB(A). In this case you will need to introduce
noise protection measures for the user. The
noise generated by this electric tool was
measured in accordance with EN 60745-1.
Vibration measured on the handle acc. to EN
60745-1.
Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
16:26 Uhr Seite 7
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
7