Cleaning And Maintenance - Peg-Perego adjustable base Notice D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

are different from those indicated as there is

a risk that the base could become detached

from the vehicle's seat.

• Make sure that the vehicle' s three-point seat belt

for attaching the base and the car seat is always

taut and not twisted. It should be replaced if it

undergoes excessive stress in an accident.

• If you are unsure of anything, contact the

manufacturer or the retailer of this car seat.

• Do not remove the stickers; this could mean

that the product no longer conforms with the

standards.

• Do not use this car seat base if it is broken or

has missing parts, if it is second-hand or if it has

undergone violent stress in an accident, as it may

have extremely dangerous structural damage.

• Do not modify the product.

• For any repairs, replacement parts or

information on the product, contact the post-

sales assistance service. Details can be found

on the last page of this manual.

• Do not use this car seat base after five years

from the production date indicated on the

structure. Due to natural ageing of the materials,

it may no longer conform to the standards.

Instructions for use in car

1• Place the base for the child car seat on the seat

of the vehicle. Since not all vehicle seats slope

at the same angle, the height-adjustable base

will allow you to keep the child car seat in the

correct position, parallel to the ground.

• Position the base rear facing in the back seat of

your vehicle. Check the level indicator on the

side of the base to make sure that the pointer

is in the green area. If it is not, turn the knob

left or right until it is in the correct position.

2• Thread the vehicle's seat belt through the two

side guides of the base, making sure that it

is taut, and buckle the vehicle's seat belt, as

shown in the figure.

3• If your vehicle is equipped with a seat belt

with a free-sliding buckle (like most modern

vehicles), you must attach a Surefix Clip to

it. Using a Surefix Clip guarantees correct

attachment of the child car seat to the base.

• Remove the Surefix Clip from its housing, as

shown in the figure.

• Grab the vehicle shoulder strap (the free strap)

just above the buckle, and hold it taut while

slipping the Surefix Clip onto the free strap, as

shown in the figure. The Surefix Clip must hold

the strap taut. (Once the Surefix Clip has been

mounted correctly, it can be left on the vehicle

seat belt to make it easier to fasten the base

each time).

• Once you have fitted the "Surefix Clip", check

the inclination of the base again and ensure

that the indicator lever is in the green area.

• The base is ready for fastening the child car

seat to it.

4• Place your child in the child car seat, and

fasten the safety belt.

• The car seat must be positioned backwards, in

relation to the direction of the vehicle.

• Fasten the car seat to the base, pressing with

both hands until it clicks into place.

5• Take the vehicle' s seat belt again and pass it

behind the back-rest of the child' s car seat, placing

it in the rear guide, as shown in the figure.

6• In the car the handle must be completely

lowered forwards, near to the backrest of the

vehicle' s seat, as shown in the figure. Push the

handle forwards, making sure that it clicks. Check

that the belt is taut and locked so that it is safe.

7• To release the child's car seat from the base:

remove the vehicle's safety belt from the guide

on the back of the child's car seat, move the

handle to the transport position, lift the lever

on the backrest up and at the same time

lift the child's car seat. The base can be left

attached in the car, ready for use.