Angelo Po 191BR2EA Manuel D'utilisation Et D'installation page 52

ADJUSTING THE WELL "FULLY RAISED" MICROSWITCH
Important
This adjustment must
be made with the well
completely raised.
To carry out this operation,
proceed as follows.
1 - Undo the screws (C)
and remove the control
panel (D).
2 - Undo the screws (E) to remove the lid (F).
3 - Undo the screw (G).
4 - Position the microswitch (H) so that it is
touching the bracket (L).
5 - Tighten the screw (G).
6 - Fit the lid (F) and secure it with the screw (E).
7 - Replace the control panel (D) on completion of
the operation.
8 - Raise and lower the well to check that the set-
ting is correct.
IT
GB
DE
ADJUSTING THE LID COUNTER-BALANCING
To carry out this operation, proceed as follows.
1 - Fit the spanner (A) onto the hexagon (B).
FR
2 - Keep a firm grip on the spanner (A) and undo
the locking screws (C).
ES
3 - Turn the spanner (A) clockwise to load the
spring or anti-clockwise to release it.
4 - Once the correct balance is obtained, screw in
the screws (C) without tightening them fully.
5 - Use the spanner (A) to turn the shaft until it is
located in one of the seats provided.
6 - Fully tighten the screws (C).
English
D
C
E
C C
- 24 -
D C
F
L
H G
A A
B B
IDM-39616701000.tif
IDM-39616201500.tif
IDM-39616301600.tif IDM-39615401800.tif