Angelo Po 191BR2EA Manuel D'utilisation Et D'installation page 48

Connect the appliance to the mains electricity sup-
ply as follows.
3 - Undo the screws (F) to remove the lid (G).
4 - Connect the circuit-breaker (A) to the ter-
minal board (H) of the appliance as shown in
the diagram and in the electrical system dia-
gram at the back of the manual.
Use a flexible cable with at least type H07RN-F
characteristics, rated for an operating tempera-
IT
ture of at least 80°C.
5 - Tighten the cable gland (L).
GB
Important
When connecting, take care to connect the
DE
neutral and earth lines.
FR
ES
CONVERSION OF ELECTRICITY SUPPLY (191BR2EA - 191BR3EA)
The appliance is supplied at an operating voltage
400V/3N (indicated on the sticker applied to the da-
taplate); conversion to 230V/3 can be carried out as
described below.
English
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Undo the screws (D) and remove the control
panel (E).
A
E
D
F
6 - Fit the lid (G) and secure it with the screw (F).
7 - Replace the control panel (E) on completion of
the operation.
Before doing any work, cut off the mains elec-
tricity supply.
- 20 -
E D
G
H
L
Caution - warning
IDM-39616700900.tif
IDM-39616301300.tif