Staufenbiel Yak11 Manuel D'utilisation page 17

12
13
14
15
16
Assemble the horizontal and vertical tail as
shown.
Then place the tail assemblies on the fuselage.
Now screw the tail assemblies to the fuselage.
Also screw the yaw rubber on the underside of
the fuselage.
Connect the control linkages of the pitch eleva-
tor and yaw rudder to the rudder areas. The
linkage lengths should now be adjusted exactly
until both rudder areas are in the neutral positi-
on.
The linkage must be hooked in fully outside at
the ruder horn (pitch elevator). Secure all screw
connections with Loctite. The servo-tester can
now be disconnected from the servos again.
EN
17
www.staufenbiel-shop.com
info@modellhobby.de
+49 40 30061950