Flow Switch Installation - SIKA VH Série Notice D'utilisation

Flow switch installation

 Carry out installation of your device type as described in the table below.
Flow switch type
V- -01M...
Fig. 3
V- -05M...
V- -06M... up to DN 50
VHS06M - P...
V- -07M... up to DN 50
Fig. 4
V- -06M... from DN 50
V- -07M... from DN 50
- 30 -
Installation type and instructions
Installation with the help of brass (soldering)
threaded nipples or stainless steel (welding)
threaded nipples including O ring.
Installation in sockets with a ½"BSP female
thread
Caution:
Please observe the installation height dimensions.
VHS06M P... (Trimmable paddle)
-
Important:
In order to shorten the paddle to the required
length, use a side cutter.
When cutting, hold the paddle tight above the cut
surface
.
Installation in sockets with a ½"BSP female
thread:
- horizontal pipes (switch upright)
- vertical pipes.
Caution:
Always observe the installation height dimensions
© SIKA • Ea3000_FlowSwitch • 02/2014
VH... / VK...