Operat Ion - M Ot Or Unit S - Enduro EM303+ Manuel D'utilisateur

Always m ake sure t hat t he rollers ar e fully disengaged from t he t yres w hen t he m anoeuv ring sy st em is
not in use. This is bet t er for t he t yres and for t he sy st em .
Always m ake sure t hat t he rollers ar e fully disengaged before t owing/ m oving t he caravan by vehicle or
m anpow er. This can dam age t he t yres, m anoeuvring syst em and t he t owing vehicle.
Always m ake sure t hat aft er you have finished using t he m anoeuvr ing sy st em , t he bat t ery power
isolat ion sw it ch ( 29) is sw it ched off and t he key is r em ov ed and st ored in a safe place ( out of reach of
children or ot her unaut hor ised people) . I f y ou don't sw it ch off, t he bat t er y will be discharged by t he
sm all " st andby " current .
Always m ake sure t hat t he rem ot e cont rol handset is sw it ched off and st ored ( in t he wall holder ) in a
safe place ( out of reach of children or ot her unaut hor ised people) . I f you don't sw it ch off, t he bat t ery
will be dischar ged by t he sm all " st andby" current .
Do not r ely on t he m anoeuvring syst em t o act as a brak e.
Always apply t he handbrake aft er m anoeuvring, before disengaging t he drive rollers from t he t yr es.
Do not use t he m anoeuvring syst em as a support when j acking up t he car avan, since t his can dam age
t he dr ive unit .
Depending on t he w eight of t he caravan, t he m anoeuvr ing syst em cannot overcom e all obst ruct ions
wit hout assist ance. Please use wedges as a ram p.
All w heels and t yres on t he caravan m ust be of t he sam e size and design. I f t yres are wor n or new
t yres are fit t ed, t he dist ance bet w een t he drive roller s and t he t yres m ay need readj ust ing ( see
"I nst allat ion - Mechanical Com ponent s") .
Sensit ive obj ect s such as cam eras, DVD- Play ers et c. Must not be kept in t he st owage box near t he
cont rol unit or t he m ot or cable. They can be dam aged by t he elect rom agnet ic fields.
Do not m ake any m odificat ions on t he caravan m anoeuvring syst em ( m echanical or elect ronically ) .
This can be very dangerous! No warrant y claim w ill be accept ed and we cannot guarant ee t he funct ion
of t he sy st em if any m odificat ions ar e m ade. We will not be liable for any dam age w hat soever caused
as a result of incorrect inst allat ion, operat ion or m odificat ion.
OPERATI ON – M OTOR UN I TS
The m anoeuvring syst em has t wo m ot or unit s ( 1 & 2) . I n general t hey are m ount ed in fr ont of t he axle of t he
caravan. Bot h unit s ar e ident ical but cannot be sw it ched.
Fig. 4
A. Alum inium dr iv e roller
B. Driv e unit including 12V m ot or
C. Plast ic m ot orcover
D. Base unit including plast ic cover
E. Plast ic gear cover
I n order t o engage t he rollers, fit t he end socket of t he engagem ent t ool ( 6) on t he spindle ( Fig. 9) on t he right
or left dr ive unit and t ur n t he handle ( Fig. 10) .
Tr a ct ion in dica t or la be l:
The yellow - green- r ed t ract ion indicat or label ( Fig. 11A) , on t he side of each m ot or unit indicat es if t he roller is
depressing t he t yre sufficient ly t o provide adequat e t ract ion.

I f t he point er is in t he yellow area – Roller s are not t ouching or depressing t he t yre sufficient ly.

I f t he point er is in t he green area – Roller s should be connect ing correct ly t o t he t yre ( m argin of 15m m )
 I f t he point er is in t he red ar ea – Roller s are connect ed t o t he t yre but in an ext rem e posit ion. I t could be
t hat t he t yre of t he caravan has insufficient air pressure or t he dr ive unit has been knocked out of posit ion
and a visit t o a workshop is r equir ed t o reposit ion t he assem bly.
® +
EN EM303 32
D URO
+
Ref: EM303 - UM- TKI - 0116- Rev.A.