Mounting The Powered Mixing Paddle And Setting The Immersion Depth In The Tank; Setting The Speed Or Gear At The High- Speed Mixer; Connect Dust Extractor; Operation And Control - Baier BMK 120 Traduction Du Mode D'emploi Original

•
10 With the mains plug plugged in and the
high-speed mixer switched off, press the −ON−
button (RESET) (2). The red indicator light (1)
must light up.
•
Press the −OFF− button (TEST) (3). The
10
PRCD must switch off, i.e. the red indicator light
(1) goes out.
• Press the −ON− button (RESET) (2) again.
10
The high-speed mixer must now be able to be
switched on.
•
If the PRCD does not trip during the test, or if
it repeatedly switches off when the high-speed
mixer is switched on, the high-speed mixer
together with the PRCD personal protection
switch must be examined by a qualified
electrician.
5.2 Mounting the powered mixing
paddle and setting the immer­
sion depth in the tank
DANGER
Risk of injury due to electric shock.
Î Disconnect the mains plug of the high-speed
mixer before carrying out any work on the mix-
ing station.
Mounting the powered mixing paddle
•
Select the suitable powered mixing paddle for
the mixture.
•
11 Mount the powered mixing paddle (1) in
accordance with the instruction manual of the
high-speed mixer (2) used.
Setting the immersion depth in the tank
•
1 Hold onto the handle (2) of the machine
retainer (17).
•
1 Release the clamping lever (16).
•
Move the machine retainer (17) with high-
1
speed mixer (1) and powered mixing paddle (5)
to the required height.
•
Tighten the clamping lever (16).
1
5.3 Setting the speed or gear at the
high­speed mixer
•
Set the speed or gear in accordance with the
instruction manual of the high-speed mixer used
and the respective mix.
5.4

Connect dust extractor

•
12 Place the cover (1) on the tank and press
firmly until it latches into position.
•
Check the dust extractor to ensure that it is
working properly.
•
Push the dust extractor hose (3) firmly onto
12
the nozzle (2) of the cover (1).
NOTE
10 The nozzle (2) is designed to fit the suction
hose (3) of a BAIER special dust extractor.
10 When the extraction hose (3) is cold a good
deal of effort is required to push it onto the
nozzle (2) of the cover (1).
6

Operation and Control

DANGER
Risk of poisoning due to toxic gases.
Risk of explosion, burns and fire due to flammable
gases and dust.
Î Do not process liquids or materials with
unknown hazard potential.
Î Note and follow the processing, use and safety
regulations of the mixing material manufacturer.
Î When processing plastics, paints, varnishes
and similar materials, do not work near flam-
mable gases or materials.
WARNING
Risk of injury due to winding of the mains cable on
the rotating powered mixing paddle.
Î Route the mains cable to the side or rear away
from the mixing station.
•
Switch on PRCD switch (only included for USA
variant).
•
Switch on the external ON / OFF switch on the
square tube of the tank retainer (only installed
on the USA variant).
•
Switch on the dust extractor.
•
Switch on the high-speed mixer.
•
Gradually add the mix material and liquid to
the tank, according to the mix manufacturer's
instructions.
| 29 |