Inserting The Tank In The Tank Retainer; Mounting The Machine Retainer; Inserting The High-Speed Mixer Into The Machine Collar; Mounting The External On / Off Switch (Usa Variant Only) - Baier BMK 120 Traduction Du Mode D'emploi Original

EN
•
5 Match the holes in the U-sections of the
height adjustment, left (3) and right (5) on the
chassis (4) with the welded on nuts M10 in the
U-sections of the height adjustment (2) / (8) of
the tank retainer (1) at the required height.
•
5 On each side, screw in two cheese head
screws (6) with plain washer (7) through the two
U-sections into the welded on nuts M10 and
tighten (tightening torque: approx. 50 Nm).
4.4 Inserting the tank in the tank
retainer
•
6 Insert the tank (1) into the tank retainer (2),
the pouring spout of the tank faces the front.
4.5

Mounting the machine retainer

•
7 Undo the clamping lever (3) on the square
tube of the tank retainer (2).
•
7 Push the height-adjustment tube of the ma-
chine retainer (1) into the square tube of the tank
retainer (2), the machine collar faces the front.
•
7 Move the machine retainer (1) to the required
height.
•
7 Tighten the clamping lever (3) on the square
tube of the tank retainer (2).
4.6 Inserting the high­speed mixer
into the machine collar
•
8 Undo the two cheese head screw (3) in the
machine collar (2).
•
8 Insert the high-speed mixer (1) into the ma-
chine collar (2) from above up to the limit stop.
•
8 Re-tighten the cheese head screws (2).
4.7 Mounting the external ON / OFF
switch (USA variant only)
•
9 Use two O-rings to fix the external ON / OFF
switch (1) onto the square tube of the tank
retainer.
•
Ensure secure fixing of the external ON / OFF
(1) switch.
| 28 |
NOTE
The external ON / OFF switch is only included in
the USA variant (ID No. 9567).
5

Before Starting Work

To ensure safe working with the mixing station, the
following points must be observed before each use:
•
Read through all safety instructions and hazard
notices in this instruction manual, the instruction
manual of the high-speed mixer used, and
the safety instructions supplied with the mix
material.
•
Wear protective clothing such as hard hat,
hearing protection, safety footwear, face
protection or safety goggles, safety gloves and if
necessary, an apron.
•
The voltage on the rating plate of the high-speed
mixer must be identical with the mains voltage.
•
Before each use, always check the mixing
station, high-speed mixer, connection cable and
plug.
•
Connect a suitable dust extractor (e.g. BAIER
special dust extractor) to the mixing station.
•
The mixing station is stood on a flat, firm
surface.
•
1 The locking devices (10) of the two rear
swivel castors (9) are actuated.
•
The high-speed mixer is securely fixed on the
mixing station.
5.1 Testing the personal protection
switch (USA variant only)
DANGER
Risk of injury due to electric shock.
Î
1 / 10 The PRCD personal protection switch
must be tested before each use of the high-
speed mixer (see below). If the PRCD does not
trip during the test, or if it repeatedly switches
off when the high-speed mixer is switched on,
the high-speed mixer together with the PRCD
personal protection switch must be examined
by a qualified electrician.