IARP AB 500 P Instructions D'emploi Et D'entretien page 13

HANDLING
The unit is shipped anchored onto a wooden
base and protected by corner posts, cardboard
top and nylon wrapping.
It must only be handled using a fork lift truck
with adequate power to the load.
Positioning the appliance horizontally or on its
side or upside down is to be strictly avoided.
The equipment MUST be kept vertical.
INSTALLATION
Appliance suitable for packaged foodstuff preservation.
After unpacking, thoroughly clean the entire bench with warm water and 5% mild soap and then
dry it with a soft cloth.
The distance from the wall should be at least 10 cm.
Adjust the feet with respect to the support plane
of the rollers.
Position the appliance on a level surface away
10 cm
from heat sources that is not exposed to sunlight.
It is essential for the condenser unit to be able to
exchange air freely; therefore, the air grills must
not be obstructed by boxes or anything else.
Do not position the appliance outdoors or expose
it to rain.
Do not use electrical appliances in the
refrigerated compartment.
The appliance is not suitable to withstand spills
of liquid on top of it.
Therefore, do not rest or place containers with
liquids immediately above the refrigerated
cabinet.
Install and position the appliance so that the
power plug is easily accessible.
THE APPLIANCE IS NOT SUITABLE FOR
INSTALLATION IN AREAS WITH DANGER
OF FIRE OR EXPLOSION OR EXPOSED
TO RADIATION.
-13-