Conversion To Another Type Of Gas - Gaggenau VG 295 CA Notice De Montage

Conversion to another type of gas

This gas stovetop corresponds to the categories
specified on the rating plate. By changing nozzles, it is
possible to convert the appliance to any of the gases
listed on the plate. The conversion kit can be obtained
from our customer service. With some models, the
conversion kit is included in the scope of delivery.
Only a licensed specialist is authorized to switch the
appliance to another gas type.
Before carrying out the conversion, turn off the
electricity and gas supply.
Changing the low burn nozzle
1 Remove pan supports and all burner parts.
2 Remove control knobs. Unscrew fastening screws
(three 7 mm nuts on each burner and two Torx T20
on the wok burner) and and carefully detach
stovetop.
3 The low burn nozzles are located in the gas valve
and are screwed in from above. Turn the black
plastic part so that the recess is above the nozzle.
Screw out nozzle and take nozzle out with small
pliers.
4 Insert the new nozzles as specified in the nozzle
table. The nozzles must be screwed in fully.
Changing the full burn nozzle: normal and large
burner
1 Detach the securing clips from the burner pipes.
Unscrew the burners and extract the burner pipes.
The electrode can be left connected. Extract the
burners from the burner pipes.
2 Extract the nozzles from the burner pipes by hand
and extract the O-ring.
3 Check correct fitting of the O-ring in the new main
nozzles. Slide the nozzles onto the burner pipes.
Do not bend the burner pipes!
4 Fit the burners onto the burner pipes. Fit the
burners. Screw down the burners.
5 After loosening the screw, adjust the outer burner's
air regulation sleeve to the correct dimensions (see
nozzle table - L1). Tighten the screw again.
6 By turning or moving it, adjust the inner burner's air
regulation sleeve to the correct dimension (see
nozzle table - L2).
7 Fit the cooktop and screw it down evenly. Fit burner
parts and pot supports, paying attention to correct
positioning.
8 Set the pressure regulator to the correct pressure
(see "Connect gas supply").
11