Ribimex Ribiland PRMPP087 Traduction Des Instructions D'origine page 33

6.3- Long Term Storage
When it is not in use for a long time and needs storing, please drain off the fuel in the fuel tank and
the cylinder. The long-term storage with fuel in them will cause the block inside the cylinder and
the failure of the engine (hard to start or lower output of the power).
1. Please leave the tank cap a bit open in storage. Being tightened may lead to the deformation of
the cap. If the pump is not in use for more than a mouth, store it at the places where there is less
dust and lower humidity after it is repaired as follows:
2. Drain off the fuel from the fuel tank.
3. Refill the pump with water and start the engine. Keep it running at low speed until the fuel is
used up.
4. Remove the spark plug and refuel 1-2cc of motor oil for 2-cycle engine into the cylinder. Pull out
the hand starter 2-3 times.
5. Replace the spark plug as it was and pull the starter. Release the starter grip at the position where
you feel it hard to pull.
6. Drain off the water in the pump thoroughly and wipe out the water with a rag
7. Before storing the machine, repair or replace any worn or damaged parts.
8. Remove the air cleaner element from the carburetor and clean it thoroughly with soap and water.
Rinse and dry thoroughly, then add a few drops of oil and work it in. Reassemble.
9. Store the machine in a clean, dust-free area.
Product must be stored in a dry location. Always lock up product and keep out of reach of children
6.4- Disposal
When disposing of your machine, remove oil and fuel from the machine, and be sure to follow the
local regulations. Do not dispose of in/with household rubbish
6.5- Troubleshooting
Phenomena Cause
The starter The wheel of the starter
rope cannot be lead is struck or blocked
pulled out. by other things.
The crankshaft The engine is burnt or
is not running. blocked by other things.
The fuel is inferior.
(Impurity, regenerated)
The fuel is sucked too
much.
The muffler exhaust
The engine
The damage, short circuit,
cannot be
and breakage if the spark
started.
plug electrode
The blockage of the
carburetor
The damage of the piston
and the cylinder
Handling method
Disassemble and repair (Competent servicing dealer)
Disassemble the engine and replace the damaged
parts (Competent servicing dealer)
Replace it.
Turn on the throttle fully and pull the starter
continuously.
Clean it.
Clean the electrode or replace the spark plug. Check
and replace the circuit.
Disassemble and repair the carburetor. (Competent
servicing dealer)
Disassemble and repair the engine. (Competent
servicing dealer)
- 30 -