Ribimex Ribiland PRMPP087 Traduction Des Instructions D'origine page 26

1 2 3 4
1. Handle
2. Hexagon flange bolt M8×20
3. Plastics tube
4. Flange locked nut M8
5. Flange locked nut M8
6. Bracket
7. Flange locked nut M8
8. Hexagon flange bolt M14
4.3- Hose assembly
Important: use only a PVC suction ringed hose or other hose with similar quality (not included).
Assemble the intake hose joint and the intake (suction) hose (not supplied) and drain hose to the
water pump. Proceed as follows;
1. Insert the couplings into the suction and discharge hoses
2. Use the clamps and tape (not supplied) and tighten firmly.
Then screw the hose couplings to the pump suction inlet and discharge port.
3. Insert strainer in suction hoe.
4. Use the clamps and tape (not supplied) and tighten firmly
Note: Make sure the washer is properly fitted on the intake hose coupling.
If the washer of the suction hose is loosened, or the hose buckle is lost or damaged, the water will not
5 6 7 8
be pumped properly due to air leakage
9 10 11 12 13 14 15 16
9. Gasket φ14
10. Bracket
11. Hexagon flange bolt M8×20
12.Plastic flat gasket
13. Wheel
14. Iron tube
15. Plastic flat gasket
16. Hexagon flange bolt
- 23 -