Ribimex Ribiland PRMPP087 Traduction Des Instructions D'origine page 23

9. Don't get product close to inflammable materials such
as ropes, dead leaves, waste paper and oilcloth etc.
10. After refueling, screw the fuel cap back tightly onto
the fuel tank and then carry the product to a spot 3m
or more away from where it was refueled before
turning on the engine.
11. Refueling
 Never store cans of fuel or refill the fuel tank in any place where is a boiler stove, wood fire,
electrical sparks, welding sparks or any other source of heat or fire which might ignite the fuel.
 Don't smoke when handling the fuel.
 When refilling the tank, always turn off the engine first and take a careful look around to make
sure that there are no sparks or open flames anywhere nearby before refueling.
12. If any fuel spillage occurs during refueling, use a dry rag to wipe up spills before turning the
engine back on again.
13. Do not transport this unit on an uneven surface of the road for a long time when the fuel tank is
full. This may cause fuel spillage after the tank cap is loosened as a result of bumping and
impacting.
14. Before starting engine, keep children and animals out of the working area.
15. Never touch the muffler, spark plug and plug wire while the engine is in operation or
immediately after stopping the engine. Doing so could result in electric shock and/or serious burns
because of high temperature.
16. For safe operation, use caution and keep the children away from the spot where the engine is in
operation.
17. The working temperature should be within 5C and 60C. Otherwise; the pump is easy to get
damage.
18. Never use the pump without water in it. Doing so could result in serious damage of the pump.
19. Be sure to use a suction hose (not included).
Please use hose buckles and hose tape (not included) when connecting the suction hose (not
included) and the drain hose (not included) with the water pump,
20. Do not move the water pump until the engine is turned off and the pump has stopped rotating.
- 20 -