Ribimex Ribiland PRMPP087 Traduction Des Instructions D'origine page 27

PRPMC208
PRMPP087
.
4.4- Before starting engine
Note: Check that both suction hose and discharge hose are properly assembled.
Note: Press the fuel priming bulb at the bottom of the carburetor several times with your fingers
before starting until the fuel flows into the transparent plastic bulb..
Note: Before each use, ensure that both fuel tank and oil tank are fully filled in. Refill if necessary
1. Fill water into the self-priming port [4] to make the intake hose and the water pump full of water.
Proceed as follows:
For PRMPP087
1. Remove cap 2. Fill in with water 3. Replace cap
- 24 -