Symbols
III. SAFETY INSTRUCTIONS
Before using this product, carefully read this manual and familiarise yourself with its content and
understand all safety instructions.
Do not operate or service the product unless you clearly understand this manual.
Always follow the safety instructions to minimize risk of damage to property, and to minimize any
risk of damages and injuries to yourself and other persons and/or animals.
Keep the manual with the product or in a safe place, so that you can read it whenever you have a
question about its use or servicing.
Safety notes and attention statements should always be observed.
3.1- GENERAL SAFETY INFORMATION
1. Keep work area clean
Cluttered areas invite accidents and injuries.
2. Consider work area environment
Do not expose product to rain or to humidity.
Do not use product in damp or wet locations, during weather conditions.
Keep work area well lit (natural light or sufficient artificial lighting).
Do not expose to weather conditions (ex.: storm, rain, snow ...) or moisture.
Do not use during weather conditions.
Caution! Risk of injury and/or damage and/or deterioration of product in
case of non compliance to safety requirements.
Read the instructions manual.
Make sure all users read the instructions.
Keep this manual for future reference
Wear protective equipment (face shield or goggles, ear protection)
Your hearing is at risk of irreparable damage. Anyone operating this machine
under conditions during conscious daily use may be exposed to a noise level
equal to or exceeding 85 dB (A). The operator must wear Personal Protective
Equipment (PPE). In order to protect the operator's hearing.
Wear protective gloves and boots.
Never operate this tool or any other power equipment if you are tired, ill, or
under the influence of alcohol, drugs, or any substance that could affect your
ability or judgement.
Danger: Fire!
Fuel is inflammable. Do not spill!
Keep away from naked flames. Do not smoke. Do not spill fuel.
Never attempt to refill while the motor is running or hot!
Warning! Hot surfaces!
During operation and for a certain time after the machine has been switched
off, cylinder, motor casing etc. will be hot.
Do not touch them until they have cooled down. You risk getting burned.
- 17 -