Honda WB20XT Guide De L'utilisateur page 32

<WB30XT>
a. Place an approved gasoline container below the carburetor, and use a
funnel to avoid spilling fuel.
b. Move the fuel valve lever to the ON position and loosen the carburetor
drain bolt by turning 1 to 2 turns counterclockwise.
c. After all fuel has drained, tighten the carburetor drain bolt securely, move
the fuel valve lever to the OFF position.
4. Change the engine oil.
5. Remove the spark plug, and pour about a tablespoon of clean engine oil into
the cylinder. Crank the engine several revolutions to distribute the oil, then
reinstall the spark plug.
6. Pull the starter grip slowly until resistance is felt. This will close the valves so
moisture cannot enter the engine cylinder. Return the recoil starter grip
gently.
7. Cover the pump to keep out dust.
WASHER
DRAIN BOLT
FUEL VALVE LEVER
ON
29