Pre-Operation For Starting - Honda WB20XT Guide De L'utilisateur

Before each use, look around and underneath the engine for signs of oil or
gasoline leaks.
1. Connect the suction hose.
Use commercially available hose, hose connector, and hose bands.
The suction hose must be of reinforced, noncollapsible construction. Suction
hose length should not be longer than necessary, as pump performance is best
when the pump is not far above the water level. Self-priming time is also
proportional to hose length.
The strainer that is provided with the pump should be attached to the end of
the suction hose with a band, as shown.
CAUTION:
Always install the strainer on the end of the suction hose before pumping. The
strainer will exclude debris that can cause clogging or impeller damage.
SUCTION PORT

4. PRE-OPERATION FOR STARTING

HOSE
CONNECTOR
HOSE CONNECTOR
HOSE BAND
SUCTION HOSE
SEALING WASHER
HOSE COUPLING
HOSE CLAMP RING
HOSE BAND
SUCTION HOSE
STRAINER
HOSE BAND
9