Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To keep the machine in good working condition, simply perform the following maintenance procedures.
FOR SAFETY: Before leaving or servicing machine, stop on level surface, turn off machine, remove key and
set parking brake if equipped.
FOR SAFETY: When servicing machine wear personal protection equipment as needed. All repairs must be
performed by trained personnel.
AFTER DAILY USE
1. Drain and rinse out the recovery tank.
2. Drain and rinse out the solution tank.
3. Disk scrub head - Turn pad over or replace when
worn.
4. Remove the brush plate, clean the brush plate and
the residue on the edge of the water skirt. Check
the edge of the wash skirt for wear or damage. If
worn or damaged, replace.
5. Wipe the squeegee blades clean. Inspect blades
for wear and damage . Rotate blade if worn.

- MACHINE MAINTENANCE -

6. Clean the outside surface of the machine with an
7. Remove the drip trap cover from the squeegee as-
8. Take off the charging line from the wire hook, and
ATTENTION: Do not disconnect battery cables
while charger is plugged in, circuit board damage may
result.
all purpose cleaner and damp cloth.
sembly and clean reservoir.
then insert the other end of the charger and then
insert the power supply for charging.
English
| 35
| 35
| 35

Publicité

Table des Matières
loading

Table des Matières