Installing Batteries; Battery Specifications; How The Machine Works - Cleanfix RA705 IBC Mode D'emploi

INSTALLING BATTERIES

WARNING: Batteries emit hydrogen gas. Explosion or fire can result. Keep sparks and open flame away
when charging.
FOR SAFETY: When servicing machine, wear appropriate personal protection equipment as needed. Avoid
contact with battery acid.

BATTERY SPECIFICATIONS

Requires four 6 volt deep-cycle batteries, ≤ 260 Ah @ 20 hr.
Contact distributor or Cleanfix for battery recommendations.
FOR SAFETY: Before leaving or servicing machine, stop on level surface, turn off machine, remove key and
set parking brake if equipped.
1. Lift the recovery tank to access the battery com-
partment.
FOR SAFETY: When servicing machine, use a hoist
or adequate assistance when lifting batteries.

HOW THE MACHINE WORKS

Conventional scrubbing:
When using the conventional scrubbing mode, water and detergent mixture from the solution tank flows to
the floor and the rotating brush(es)/pad(s) scrub the floor clean. As the machine moves forward, the squeegee
with vacuum suction picks up the dirty solution from the floor into the recovery tank.
28 | 28 | 28 | English
2. Carefully install the batteries into the battery com-
partment tray and arrange the battery posts as
shown. Position foam spacer between batteries as
shown.
3. Using the supplied battery post boots, connect the
cables to battery posts,
RED TO POSITIVE (+) & BLACK TO NEGATIVE (-).