Seal The Case; Attach The Diffuser; Check The Operation Of The Loaded Camera - Olympus PT-EP12 Mode D'emploi

Seal the Case

1 Close the Case gently while aligning the mounting projection of the rear lid and groove.
2 Turn the open/close dial counter clockwise (1 of figure below) until lock.
• The Case is sealed.
3 Slide the lock knob towards the LOCK side (2 of figure below).
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This will cause water leakage.
• Close the rear lid of the Case so that the lens cap, silca gel or monitor hood strap doesn't catch. If it catches,
water leaks may result.

Attach the diffuser

• Do not cap to optical fiber cable insertion slot.
• For details of how to attach the diffuser, refer to "Using the diffuser" (P.9).

Check the operation of the loaded camera

EN
After sealing the Case, check that the camera operations normally.
• Push the ON/OFF button on the Case and confirm that the camera turns ON/OFF.
• Turn the mode dial on the Case and confirm that the camera mode switches properly.
• Press the shutter lever on the Case and confirm that the camera shutter releases.
• Operate other control buttons on the Case and confirm that the camera functions properly as intended.
EN 15
Close
1
Open/close dial
Lock knob
2