STARFRIT ROTATO Express Mode D'emploi Et Recettes page 4

HOW TO CHANGE THE BLADE
Rotato Express blades are specially designed to give clean and easy
peeling or cutting. When the blade skips or jams, or is excessively
clogged, it's time to change the blade.
1. Turn the Rotato Express upside down and open the blade storage
compartment located underneath the base and remove one of the
new blades.
2. Remove the cutter head by gently pulling the lock-in attachment
from the cutter arm.
3. Unlatch and slide the used blade away from the blade holder. Dispose
of the used blade using the same precautions taken with a sharp
razor.
4. Slide the new blade down the ridge of the blade holder. Make sure
the blade is solidly in place before proceeding to the next step.
5. Put the cutter head back on the Rotato Express by inserting the lock-
in attachment into the cutter arm.
FOR EASY CLEANING
WARNING: Do not immerse in water. You can clean your Rotato Express
with a damp cloth. It is recommended to remove the batteries and the
entire cutter head and wash separately.
ELECTRICAL ADAPTOR
As an alternative to batteries, an electrical adaptor can be plugged in the
back of the unit. Always select a 6.0 Volt, 600 mA adaptor with the input
/ output polarity as follows: - ___(•___+. When not in use, unplug the
adaptor.
WARNING
Disconnect the adaptor from the Rotato Express and remove the batteries (if
installed) prior to changing accessories or touching the blade holder. Batteries
must be removed from the Rotato Express before it is discarded. The batteries
should be disposed of safely and in accordance with national regulations.
4