Maintenance; Spare Parts - Wolf Garten UV 29 EV Mode D'emploi

Setting the working depth
1
Make sure the motor is switched off and the cutting bla-
des are not moving.
1. Pull the lever out.
2. Set the desired working depth.
3. Press the lever back in.
3
Note concerning blade wear:
If the blades are visibly worn down
king depths can be used. Cut the plastic strap away in the
front area of the working depth setting using a knife

Maintenance

General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
pull out the power plug.
Do not touch running blades.

Spare parts

Item number
3618 065
3618 050
Supplied by your dealer .
14
H
J , two additional wor-
K
Order description
TK 30
Recommended working depths
.
Starting up the engine
1. Depress button (1) and hold.
2. Lift up bar (2) and release button (1).
Switch-off motor: Release bar (2).
1
Important:
Place the cable fi rmly off the lawn or on the already cut side of
the lawn when starting to mow.
Cleaning
Clean the unit thoroughly with a brush after each use.
Do not spray with water.
Store unit in a dry room.
3
We recommend
Allow a WOLF-service centre to check the unit in the autumn.
Transport
uneven lawn surface
Clean lawn surface
unkempt, extremely mossy
lawns
Worn blade
Worn blade
L
Product information
Complete grass collecting basket
Replacement cylinder
G