Maintenance; Spare Parts - Wolf Garten AMBITION 34 E Notice D'instruction D'origine

Set cut height
L
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
1. Pull the lever out (1).
2. Set the desired cutting height (2).
3. Press the lever back in (3).
3
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf.
Do not se cutting position too low when mowing very hight
or wet grass.
Connecting to the mains (230 Volts, A.C., 50 Hz)
z The mower operates from any normal household mains sup-
ply, provided with a 16 Amps. fuse.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
z We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
z Retrofit kits are available for old installations. Consult an
electrician.

Maintenance

General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z pull out the power plug.
z Do not touch running blades.
Cleaning
z Clean mower thoroughly after each mowing with cloth or
brush.
z Do not spray with water.
Winter Storage
z Clean mower thoroughly before storing away.

Spare parts

Item number
WG742-04356
WG742-04357
WG742-04358
12
Starting and Stoping
z Switch on motor with mowerplaced on level and firm ground.
z not in high grass - alternatively tilt slightly
Switch-on motor
1. Depress button and hold (1).
2. Lift up bar (2).
3. Release bar (1).
Switch-off motor
z Release bar (2).
Emptying of Grassbox
When the collection bag is full, the flap lowers by itself
1
3
Tips for mowing
z To prevent strips of grass from being left unmowed, the cutting
z Always let cable trail on the cut side of the lawn.
z Have your mower thoroughly checked once a year by an ap-
z Do not store it in a wet or humid place.
Changing blades
z For all works on blades, coupling and cutter bars, first of all,
1
z Always change blades in a specialist workshop. A torque
Order description
Vi 34 C
Vi 38 C
Vi 42 C
N
N
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Empty collection bag.
z Remove potential blockages in the cutting space before
starting.
Instructions for level indicator:
For an efficient functioning of the level indicator, regularly
clean the holes under the level indicator in the collection
bag with a hand brush.
paths must always overlap a few centimeters
proved Service Centre.
Q
pull out the power plug and wear protective gloves.
Attention!
An unbalance can develop after regrinding of the blade.
z Always regrind the blades in a specialist workshop,
because an unbalance check should be undertaken
according to the safety regulations.
spanner of 10 mm is mandatorily required.
Fastening torque of the screws: 8 N-m.
Product information
Replacement blade 34 cm
Replacement blade 38 cm
Replacement blade 42 cm
M
.
O
.
P
.
G