Original Accessories/Auxiliary Equipment; Operation; Preparing The Surfaces To Be Glued - Parkside PNKP 105 A1 Traduction Des Instructions D'origine

Original accessories/auxiliary equipment

♦ Only use the accessories and additional equipment that are
specified in the operating instructions and compatible with the
appliance.

Operation

Preparing the surfaces to be glued:

■ Do not use flammable solvents to clean the surfaces to be glued.
■ The ambient temperature and the materials to be bonded may
not be colder than 5°C and not warmer than 50°C.
■ The area to be glued must be clean, dry and free of grease.
♦ Smooth surfaces should be roughened before gluing.
♦ Quick-cooling materials such as steel should be warmed a little
to facilitate adhesion.
1. Fold out the stand
2. Push a glue stick
3. Allow the appliance heat up for about 5 minutes.
The appliance is now ready for use.
■ 42 │ GB
. Put down the appliance.
into the feeder shaft .
PNKP 105 A1