Installation - Pelgrim GVW840KOR Notice D'utilisation

Remove the microfilter (D) by unscrewing
the bayonet catch.
Remove the filter mesh by squeezing the
filter housing (see fig. 13c). Simultaneously,
pull out the filter mesh vertically.
Clean filter mesh and filter with a brush
under running water.
Reassemble the filter mesh and filter in
reverse order.

Installation

Electrical connection
230 V – 50 Hz
General
If the appliance does not have a connecting
cable and plug, then it may only be connected
to the mains by an approved installer.
Note:
The power rating and required mains voltage
are shown on the rating plate. Connection
should take place according to national and
local regulations.
If the input of the appliance exceeds 3 kW, the
appliance has to be connected to an outlet
with a rated current exceeding 13 Amp.
Technical information
Connected load kW see identification
plate
Dimensions:
Max. height mm 870
Min. height mm 820
Width mm 596
Depth mm 550
Door panel:
Max. height* mm 600
Min. height mm 500
Depth mm 598
Control panel
Max. height mm 155
Min. height mm 115
Plinth:
Max. height mm 170
Min. height mm 100
* at minimal control panel height
What else you should watch out for
Always fit tap, drainage and earthed
plug/wall socket within reach.
Make sure that the skirting-board can be
removed. It must be possible to take the
dishwasher out of its recess for
maintenance or repair work.
Connect water inlet hose/aquastop to a
self-venting water tap with a 3/4" screw
connection.
Make sure that no dirt remains in a newly-
installed water pipe.