The First Cycle - Pelgrim GVW840KOR Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The first cycle

(see fig. 2a/2b/2c)
Close the door and turn the tap on fully.
Turn the programme selection button to the
required setting (see the table for
programme selection on pages 27 – 30).
Start the machine by pressing the on/off
button (see fig. 2a, 2b and 2c). The on/off
indicator will light up.
End of programme
The dishwasher will stop automatically
once the programme has finished.
Switch the appliance off by pressing the
on/off button.
If you have selected a programme with a
drying cycle, you can empty the machine
after about 30 minutes. Keep the door
closed for that period.
Unload the dishwasher. Be careful:
– The kitchenware could be hot.
– Unload the lower basket first. If you
unload the upper basket first, drops of
water could fall on the kitchenware in the
lower basket.
Delaying the start time
Dependent on the type of dishwasher, the
programme can be set to start at a later time:
a minimum of one hour and a maximum of nine
hours later.
Models with an adjustable starting time
After switching the appliance on, you have
approximately one minute in which to set
the desired starting time, using the "M"
button.
The time remaining until the start of the
programme is indicated on the display "N".

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gvw830rvsGvw830onyGvw840rvsGvw840ony

Table des Matières