Building-In - Pelgrim GVW840KOR Notice D'utilisation

The dishwasher may be connected either
to a cold-water tap or to a hot-water tap
(maximum 60 °C).
If you connect the dishwasher to a hot-
water tap, the washing time will be
reduced by about twenty minutes.
However, the dishwasher will wash less
efficiently. The 45 °C programme will
therefore be carried out at a slightly higher
temperature.
Do not drill holes in the door or walls. The
dishwasher could be damaged beyond
repair.

Building-in

Fix the adjustable feet with the lock nuts
beneath the side panels of the machine.
Adjusting the height
The height of the dishwasher may be
adjusted from 820 to 870 mm by means of
the adjustable feet. Before you do this,
measure the height of the recess.
– It is advisable to place the appliance on a
so-called dishwasher platform.
Ask your kitchen dealer for information.
Adjusting the height of the control panel (see
fig. 14)
A
You can adjust the height of the control
panel to the height of the kitchen furniture.
This is done with the aid of the screws (A)
on the underside of the panel.
Remove the screws, springs and trim in
order to obtain the minimum height setting.
If the trim is not removed, the height can be
adjusted from 125 to 140 millimetres. With
the aid of the extra trim, you can adjust the
height of the control panel up to a
maximum of 155 millimetres.
You can get a panel height of between
120 and 125 mm by cutting a few millimetres
out of the "half moon" in the trim.
fig. 14