Cleaning; Installation - Pelgrim GVW845KOR Notice D'utilisation

Cleaning

First disconnect the appliance from the power
supply (see also page 22).
Spray arms (see fig. 9)
Take out the upper spray arm by pulling it
– with a turning movement – vertically
downwards.
Take out the lower spray arm by pulling it
vertically upwards (see fig. 10).
Rinse the spray arms clean under the tap.
Microfilter (see fig. 10)
A
C
B
Remove the filter unit by turning the clips
(A) a quarter of a turn to the left and lifting
them straight out.
Remove the microfilter (B) by unscrewing
the bayonet catch.
Press on the clips (C) and remove the filter
mesh.
Clean the filter mesh with a brush under
running water.
Reassemble the filter unit in reverse order.
Course filter (see fig. 11)
fig. 9
A
Remove the spray-arm mounting (A) by
turning it anticlockwise.
Remove the course filter (C).
Clean the course filter under running water
using a brush.
Fit the course filter, spray-arm mounting
fig. 10
and cap in reverse order.

Installation

Electrical connection
230 V – 50 Hz
General
If the appliance does not have a connecting
cable and plug, then it may only be connected
to the mains by an approved installer.
Note:
The power rating and required mains voltage
are shown on the rating plate. Connection
should take place according to national and
local regulations.
If the input of the appliance exceeds 3 kW, the
appliance has to be connected to an outlet
with a rated current exceeding 13 Amps.
B
C
fig. 11
Technical information
Connected load kW see identification
plate
Dimensions:
Max. height mm 870
Min. height mm 820
Width mm 446
Depth mm 550
Door panel:
Max. height mm 720
Min. height mm 448
Depth mm 598
Plinth:
Max. height mm 170
Min. height mm 100
What else you should watch out for
Always fit tap, drainage and earthed
plug/wall socket within reach.
Make sure that the skirting-board can be
removed. It must be possible to take the
dishwasher out of its recess for
maintenance or repair work.
Connect water inlet hose/aquastop to a
self-venting water tap with a 3/4" screw
connection.
Make sure that no dirt remains in a newly-
installed water pipe.