Control Panel And Features - Kenmore 110.44422610 Guide D'utilisation Et D'entretien

LED TIME/STATUS DISPLAY
1
The Estimated Time Remaining display shows the time
required for the cycle to complete. Factors such as load size
and water pressure may affect the time shown in the display.
Tightly packed loads, unbalanced loads, or excessive suds
may cause the washer to adjust the cycle time as well.
LID LOCK LIGHT
2
The Lid Lock indicator lights up when the lid is locked and
cannot be opened. If you need to open the lid, touch and hold
START/PAUSE. The lid will unlock once the washer movement
has stopped. This may take several minutes if the load was
spinning at high speed. Press START/PAUSE again to restart
the cycle.
START/PAUSE
3
After selecting a wash cycle, press START/PAUSE to start the
cycle. Press once to pause a cycle. The flashing lights indicate
the selected cycle and the current process.
CYCLE TIME (+ or -)
4
Press "+" or "-" to adjust the duration of a wash cycle.
■
Press "+" or "-" to adjust the duration of a spin cycle.
■
LED display will show the time remaining for the cycle
■
to complete.
If an out-of-range adjustment is made, a buzzer will sound.
■
End-of-Cycle Signal
Press and hold the plus (+) button for 3 seconds to enable
or disable the end-of-cycle signal.
14

CONTROL PANEL AND FEATURES

4
5
2
1
6 7
4
CYCLE SELECT
5
Press CYCLE SELECT to select a wash cycle. Choose from
Normal, Delicate, Heavy, Rinse, Spin, or Clean Washer.
NOTE: The washer will remember the last cycle used, with
a default load size of Medium.
LOAD SIZE
6
Press to select the water level based on the amount of
garments to wash.
When the Medium water level is selected with the Normal
or Heavy cycle, the machine will sense the size of the load
and adjust if required.
WASH TEMP
7 7
Select a wash temperature based on the type of fabric and
soils being washed. For best results and following the garment
label instructions, use the warmest wash water safe for your
fabric.
For Portable Installations: If desired, you can change the
water temperature for the Rinse cycle by adjusting the Hot
and Cold water faucets. Keep the temperature setting on
your washer set at Cold.
CONTROL LOCK
Press and hold WASH TEMP for 4 seconds to lock the controls.
Press and hold for 4 seconds to unlock. You may still press
POWER to turn the washer off.
POWER
8
Press POWER to turn the washer on or off. Press once while
a cycle is running to stop the washer.
3
8