Install Leveling Feet; Secure Drain Hose - Kenmore 110.44422610 Guide D'utilisation Et D'entretien

7.
Check for leaks
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
If you connect only one water hose, you must cap (supplied)
■
off the remaining water inlet port.

Secure Drain Hose

8.
Secure drain hose to laundry tub,
standpipe or wall
Laundry Tub
4.5"
4.5" 4.5"
(114 mm)
(114 mm) (114 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie (provided).
Do not force excess drain hose back into the rear of
■
the washer.
To avoid siphoning, do not seal or put more than 4½"
■
(114 mm) of the drain hose into drainpipe or standpipe.
Standpipe Wall
(113 mm)
(114 mm)
Install Leveling Feet – Optional
(for permanent installation only)
IMPORTANT: Installation of the leveling feet is permanent.
Once the leveling feet are installed into the base of the washer,
they cannot be removed and the washer wheels will no longer be
able to roll.
9.

Install leveling feet

4.5"
4.5"
Lay washer on its back. Push in to snap the large black rubber
foot into the right front corner of the washer base. Repeat to
install the remaining leveling feet on the other 3 corners.
Front
Large
black
rubber
foot
9