Control Panel And Features - Kenmore 110.2253 Série Guide D'utilisation Et D'entretien

1
1
WASH TEMP
Wash Temp senses and maintains uniform water temperatures
by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and
soils being washed. For best results and following the garment
label instructions, use the warmest wash water safe for
your fabric.
• On some models and cycles, warm and hot water may be
cooler than your previous washer.
• Even in a cold and cool water wash, some warm water
may be added to the washer to maintain a minimum
temperature. All rinses are cold.
2 WATER LEVEL
Set the Water Level knob to the Auto setting and the washer
will automatically sense the appropriate water level for the
load size and type.
Set the Water Level knob to the Deep Fill setting and the
washer will fi ll to the maximum water level.
NOTE: Cycle times will be longer due to extended fi ll times
when using the Deep Fill setting.
FABRIC SOFTENER
3
This option must be set to "Yes" when using fabric softener in
the fabric softener dispenser. This ensures that fabric softener
is added at the correct time in the rinse for even distribution.
WASH CYCLE KNOB
4
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
5
START/PAUSE/Unlock Lid BUTTON
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes to
unlock the lid. Press and hold for 3 seconds to cancel a cycle.
4

CONTROL PANEL AND FEATURES

2 3
Not all features and options are available on all models.
Appearance may vary.
CYCLE STATUS LIGHTS
6
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are diff erent from your previous washer.
SENSING
When the Start/Pause button is pressed, and the Water
Level knob is set to Auto, the washer will fi ll and begin
sensing to determine load size and balance.
Once sensing is complete, the washer will fi ll to the
appropriate level for the detected load size and then
begin the wash phase of the cycle.
NOTE: Sensing and wash phases will be paused by
opening the unlocked lid. Close the lid to resume the cycle.
If the lid is left open for more than 10 minutes, the washer
will cancel the cycle and pump out the water. The lid will
lock after the wash phase to begin the initial spinout and
remain locked for the remainder of the cycle.
WASH
The washer will fi ll to the correct water level based
on the load size and the Water Level selection.
Certain cycles may agitate during the fi ll process
to boost cleaning. You will hear the agitator rotate
followed by a pause lasting several seconds. When
the wash cycle begins, you will hear the agitator
increase speed. The motor sounds may change at
diff erent stages in the wash cycle while the washer
performs diff erent wash actions.
4
6
5