Control Panel And Features - Kenmore 110.3316 Guide D'utilisation Et D'entretien

NOTE: The control panel features a sensitive surface that responds to a light touch of your finger. To ensure your selections are registered, touch the
control panel with your finger tip, not your fingernail. When selecting a setting or option, simply touch its name until the desired section is illuminated.
1 POWER BUTTON
Touch to turn the washer ON. Touching once while the
washer is on will cancel the current cycle and turn the
washer OFF.
WASH CYCLE KNOB
2
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
3
ESTIMATED TIME REMAINING DISPLAY
The Estimated Time Remaining display shows the time
required for the cycle to complete. Factors such as load size
and water pressure may affect the time shown in the display.
Tightly packed loads, unbalanced loads, or excessive suds
may cause the washer to adjust the cycle time, as well.
If you have set a delay start to the cycle, the Estimated
Time Remaining display will show the delay time adjusted.
When the cycle is complete, the display will show END until
the lid is opened.
4 START/PAUSE/UNLOCK LID BUTTON
Press and hold the START/PAUSE/Unlock Lid button to begin
the selected cycle; touch again to pause a cycle and unlock
the lid.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid. Press and hold for 3 seconds to cancel
a cycle.
CYCLE MODIFIERS
5
When you select a cycle, its default settings or the previous
cycle selection used will light up.
DELAY WASH
Touch Delay Wash to delay the start of the wash cycle up
to 12 hours "12h". Touch Delay Wash until a "0h" appears
in the status display to turn off, or touch POWER.

CONTROL PANEL AND FEATURES

1 2
Not all features and options are available on all models.
Appearance may vary.
3
5
4
WASH TEMP
Temperature control senses and maintains uniform
water temperatures by regulating incoming hot and
cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results and following
the garment label instructions, use the warmest wash water
safe for your fabric.
• On some cycles, warm and hot water may be cooler
than your previous washer.
• Even for cold wash settings, some warm water
may be added to the washer to maintain a minimum
temperature.
SOIL LEVEL
Soil Level (wash time) is preset for each wash cycle. As
you touch the Soil Level pad, the cycle time (minutes) will
increase or decrease in the Estimated Time Remaining
display and a different wash time will appear.
Select the most suitable setting for your load. For
heavily soiled items, select Ex Heavy for more wash
time. For lightly soiled items, select Light for less wash
time. A lighter soil level setting will help reduce tangling
and wrinkling.
SPIN SPEED
This washer automatically selects the spin speed based on
the cycle selected. The preset speeds can be changed. Not
all spin speeds are available with all cycles.
• Faster spin speeds mean shorter dry times but may
increase wrinkling in your load.
• Slower spin speeds mean less wrinkling, but will leave
your load more damp.
CYCLE SIGNAL
Use this to adjust the volume of button sounds and/or the
signal indicating the end of a wash cycle.
NOTE: You may also turn off the tones that sound when
a feature, setting, or option is touched.
7
6
5