Control Panel And Features - Kenmore 110.2234 Série Guide D'utilisation Et D'entretien

1
1
SOIL LEVEL
Select the most suitable setting for your load. For heavily
soiled and sturdy fabrics, select Heavy Soil Level for more
wash time, if needed. For lightly soiled and delicate fabrics,
select Extra Light Soil Level for less wash time, if needed.
Lighter soil level setting will help reduce tangling and
wrinkling.
WASH TEMP
2
Wash Temp senses and maintains uniform water temperatures
by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and
soils being washed. For best results and following the garment
label instructions, use the warmest wash water safe for your
fabric.
• On some models and cycles, warm and hot water may be
cooler than your previous washer.
• Even in a cold and cool water wash, some warm
water may be added to the washer to maintain
a minimum temperature. All rinses are cold.
3
RINSE
This option is used to add additional rinse cycles.
4
STAIN BOOST
This option provides enhanced cleaning action for tough
stains. It will add additional spin and soak time to the cycle.
WASH CYCLE KNOB
5
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
START/PAUSE/Unlock Lid button
6
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes to
unlock the lid. Press and hold for 3 seconds to cancel a cycle.
4

CONTROL PANEL AND FEATURES

2 3
Not all features and options are available on all models.
Appearance may vary.
4
CYCLE STATUS LIGHTS INDICATOR
7
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are different from traditional washers.
SENSING
When the START/PAUSE/Unlock Lid button is pressed, the
washer will fill to an initial water level and begin sensing
to determine the load size. If the lid is closed when the
washer is done sensing, the lid will lock and the washer
will continue filling to begin operation. The lid will remain
locked for the rest of the cycle unless the cycle is Paused or
Cancelled.
If the lid is open when the water stops entering the washer,
the cycle will not begin until the lid has been closed and
the START/PAUSE/Unlock Lid button is pressed. If the cycle
has not been started within 10 minutes of the water filling
the washer, the washer will pump out the water.
NOTE: Avoid opening lid during sensing phase. The sensing
process will start over when the washer is restarted. The
Sensing/Fill light may also come on during the Soak and
Wash portions of the cycle. This is normal. To restart the
washer after the lid has been opened press START/PAUSE/
Unlock Lid.
5
7
6