Select Cycle - Kenmore 110.44422610 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

When Medium is selected with the Normal or Heavy cycles,
the washer will sense the size of the load and adjust the
amount of water required.
You may change the load size setting while the washer is filling.
If you change from Large to Medium but the water has filled
past Medium, you will get Medium with the next fill.
9.
Select wash temperature
Set the water temperature for the type of fabric and soils being
washed. Use the warmest wash water safe for fabric. Follow
garment label instructions.
For Portable Installations
Open the faucets connected to the water supply hoses.
Wash and Rinse water temperatures are set at your faucet.
The Temperature control does not set the temperature.
Adjust the Hot and Cold water faucets to desired wash
temperature. Keep the temperature control set at Cold.
NOTE: The Cold setting allows water from the faucet to
enter the washer, but does not control the incoming water
temperature.
For a rinse temperature that is different from the wash
temperature, you must adjust the water temperature at
the faucet after the washer has completed its initial fill.
To test the water temperature, press the red water-flow button
on the hose connector. Water will be released when the button
is pressed, allowing you to sample the temperature.
For Permanent Installations
The Rinse and Spin cycles default to a cold rinse, all other
cycles default to a warm rinse. Press the Wash Temp button
to choose a different wash temperature.
Selecting Water Temperatures
NOTE: Always read and follow fabric care label instructions
to avoid damage to your items.
Water Temperature
Hot
Warm
Cold
NOTE: In wash water temperatures colder than 60ºF (15.6ºC),
detergents do not dissolve well. Soils can be difficult to remove.
Some fabrics can retain wear wrinkles and have increased
pilling (the formation of small lint-like balls on the surface
of garments).
18
Suggested Fabrics
Whites and pastels
Durable items
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils
10.

Select cycle

Press the Cycle Select button to select your wash cycle.
See "Cycle Guide" for details on cycle features.
11.
Press START/PAUSE to begin wash cycle
Press START/PAUSE to start the wash cycle. When the
cycle has finished, the end-of-cycle signal will sound (if set).
Promptly remove items when cycle is done to avoid odor, reduce
wrinkling, and avoid rusting of metal hooks, zippers, and snaps.
Unlocking the lid to add items
If you need to open the lid to add 1 or 2 missed items:
Press START/PAUSE to pause washer; the lid will unlock once the
washer movement has stopped. This may take several minutes if
the load was spinning at a high speed. Then close lid and press
START/PAUSE again to restart the cycle.
To stop or restart your washer:
To stop the washer at any time, press START/PAUSE and the
cycle will pause.
To restart the washer, press START/PAUSE and the cycle will
resume.

Publicité

Table des Matières
loading

Table des Matières